The Adafruit STEMMA Speaker is a small plug-and-play audio board that pairs a class D amplifier with a 1 W 8 ohm speaker. It needs only ground, 3 to 5 V power and an audio signal, and the input is AC-coupled on board, so a plain microcontroller pin can drive it. Volume is set with a small screwdriver trim pot. It suits micro:bit, Circuit Playground and breadboard projects that need speech, tones or simple music, and it is simpler to wire than a bare amplifier chip plus speaker. Note it uses the 3-pin STEMMA JST connector, not the smaller STEMMA QT.
In stockShips from the UK · priced in GBP (£5.80) · duties may applyReturn policy
Owners rate it highly and describe it as an easy way to add sound to a microcontroller project. They like the simple three-wire hookup and the onboard amp. The main complaints are the modest volume and the need for the correct STEMMA cable.
The Adafruit STEMMA Speaker is an assembled board that combines a class D audio amplifier with a 1 Watt 8 ohm speaker. Connecting it takes three things: ground, 3 to 5 V power, and an audio signal.
The audio signal does not need AC coupling, which the board handles itself, and it can range up to the power pin voltage, or 3 to 5 V peak-to-peak. You can connect through the 3-pin JST socket or through the alligator/sew pads. The sound is good enough for music, tones and speech, and volume is adjusted with a small screwdriver.
It checks today's price at every store, compares the alternatives and answers in about a minute.











