

The Anycubic Photon Mono 4 is an entry-level MSLA resin printer with a 10K-class LCD, a 7-inch HD touchscreen and layer heights down to 0.02mm. It prints up to 70mm/h and resumes after a power cut, so a failed outlet doesn't waste a long job. It suits hobbyists and makers moving from filament to fine detail: miniatures, jewelry masters and small mechanical parts. Rivals in its class trade on bigger build volumes or faster mono screens, but few match its detail-per-dollar balance for a first resin printer. Owners rate it 4.3 out of 5, praising detail and setup and flagging the usual resin workflow chores.
In stockShips from South Africa · priced in ZAR (ZAR 4,253.00) · duties may applyReturn policy
Owners rate it 4.3 out of 5 and mostly praise the detail it pulls from small models and how quickly a beginner can get printing. Complaints center on the resin workflow around the machine rather than the printer itself.
The Anycubic Photon Mono 4 is an MSLA resin 3D printer that uses an LCD-based process and UV resin. It is built for printing high-detail parts at a layer thickness of 0.02 mm, the minimum it supports.
It prints at a maximum speed of 70 mm/h, and the build volume measures 153.4 x 87 x 165 mm. Settings and job monitoring are handled through a 7-inch high-definition touchscreen.
If the power cuts out mid-print, power-loss resume picks the job up where it stopped rather than starting over. The printer is covered by a 12-month manufacturer warranty.
It checks today's price at every store, compares the alternatives and answers in about a minute.