The Bambu Lab A1 is a 3D printer with a bed-slinger design and CoreXY mechanics. It has a 256 x 256 x 256 mm build volume. It comes with the AMS Lite filament system for multi-color printing.
The AMS Lite holds up to four filaments and loads and unloads them automatically. RFID sync matches print settings to Bambu filaments. The printer calibrates Z-offset, bed level, vibration resonance and nozzle pressure automatically for every print job.
It uses low-drag linear rails, accelerometers and a nozzle pressure sensor. A print status monitoring system watches the job. Active motor noise cancelling calibrates each drive motor to reduce motor noise. You can control the printer through Bambu Cloud or in LAN-only mode.
- Build volume
- 256 x 256 x 256 mm
- Motion system
- CoreXY mechanics, bed-slinger design, low-drag linear rails
- Multi-color system
- AMS Lite, up to 4 filaments, automatic loading and unloading, RFID sync
- Filament
- 1.75 mm PLA, PETG, TPU
- AMS Lite spools
- 40-68 mm width, 53-58 mm inner diameter
- Calibration
- Automatic Z-offset, bed level, vibration resonance and nozzle pressure
- Nozzle
- 1-clip quick swap nozzle
- Sensors
- Accelerometers, nozzle pressure sensor
- Features
- Active flow rate compensation, active motor noise cancelling, print status monitoring
- Connectivity
- Bambu Cloud Service or LAN-only mode
- Compatibility
- Connecting the A1 to AMS, AMS 2 Pro or AMS HT requires an AMS HUB (SA013) accessory