
Bambu Lab H3C 9 Toolhead 3D Printer with Filament & AMS H3
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
It checks today's price at every store, compares the alternatives and answers in about a minute.
The Bambu Lab H3C is a tool-changer 3D printer with nine independent PrintTools, each with its own filament path and heater. Swaptek switching changes materials in as little as 6 seconds with purge waste as low as 0.038 g, so multicolor and multi-material jobs waste far less filament than single-nozzle AMS setups. It pairs with the enclosed AMS 3H, which holds nine sealed spools and dries filament at up to 85°C, and the printer itself has a 65°C heated chamber and a 350°C hotend. It suits makers running frequent multi-material work who want less purge and faster swaps than a one-nozzle machine, at the cost of a large, complex, high-maintenance setup.
In stockReturn policy
The Bambu Lab H3C is a 3D printer with a nine-tool changer. Each of its nine PrintTools keeps its own filament loaded, heated and ready, so the machine can switch materials in about 6 seconds, with a tool change in 3.4 seconds. Active Pre-Heat warms the next nozzle while the current one is still printing, and purge waste is as low as 0.038 g per change.
It pairs with the AMS 3H, a fully enclosed filament system with nine sealed slots. The AMS detects a spool in any slot and loads the filament into its PrintTool automatically. Two dedicated drying slots reach 85°C for drying PA, PC, PET, TPU and carbon-fiber filaments, on demand or mid-print with selected materials. Existing Bambu Lab AMS units can connect through PrintTool No. 1 for up to 24 spools in a single print.
All nine hardened-steel nozzles reach 350°C, and the actively heated chamber holds up to 65°C in two zones. Travel speeds reach 1,400 mm/s with acceleration up to 25,000 mm/s², and four layers of cross-flow cooling handle overhangs and bridges. The FlexFeed extruder takes 1.75 mm and 2.85 mm filament, prints TPU as soft as 75A, and the machine can carry nozzle sizes from 0.2 mm to 0.8 mm at once. Optional CraftTools add cutting, drawing, debossing and foil transfer.





