This clutch cover is an aluminum replacement for the stock cover on select Stihl chainsaws. It is made from 6061-T6 aircraft aluminum in the USA and is stronger than the factory cover. It is field tested.
The cover is larger than stock for better chip management. It has an extra large polyurethane chip deflector that lasts longer. The cover is wider, so the chain can be walked back on without removing the cover. Because it is bigger than the stock cover, it is slightly heavier.
The cover is made for function. Slight machine marks may be present, and they can be sanded and polished to a mirror finish. Bar nuts, chain sliders and one chip deflector are included.
- Material
- 6061-T6 aircraft aluminum; polyurethane chip deflector
- Origin
- Made in the USA
- In the box
- Clutch cover, bar nuts, chain sliders, 1 chip deflector
- Bar nut torque
- 20-25 ft-lbs
- Felling dogs
- Fits 3- and 4-point Westcoast Saw felling dogs and stock dogs
- Compatibility
- The 261/MSA300/362/400 cover fits the full wrap 362 (R model) with Stihl part number 1140 021 1105. Older 261 models may need Stihl part number 1141 021 1130.
- Bar nut type
- Standard and captive bar nut covers are made separately and cannot be retrofitted to each other
- 404 chain
- May require shaving 0.015 in off the chain slider for the added width
- Installation
- Install felling dog bolts from the inside of the cover, facing out, with the nut on the outside of the felling dog. Lay the cover flat and pound the chain sliders down until they stop against the cove