Compared across 13 stores. Prices are checked against each store and labelled with when.
It checks today's price at every store, compares the alternatives and answers in about a minute.
The DeWalt DCN930 is a 20V MAX XR brushless cordless framing nailer that drives up to 3-1/2 inch paper-collated 30-degree nails, so you can frame walls and lay subfloor without a compressor or hose. Its Active Flywheel stays spinning for 6 seconds after the trigger is released, cutting ramp-up time between shots in rapid sequential work. A toe-nailing nose design helps with angled placement in tight framing spots. It is sold as a tool only, so it suits crews already on the DeWalt 20V MAX battery platform; against pneumatic framing nailers it trades unlimited runtime for freedom from hoses and setup.
In stock
In stock
In stockSold by Mass Depot LLC
In stock
In stockPriced in GBP (£433.92)Return policy
Availability unknown
Availability unknown
Availability unknown
Availability unknown
Availability unknown
Availability unknown
Availability unknown
Availability unknown
Lowest price we've seen: $334.99 on Nov 12 at Tool Nut. Tracked across 12 stores since Nov 12.
Rated 4.5 out of 5 from 28 ratings. Owners treat it as a capable cordless substitute for a pneumatic framing nailer, with the flywheel system drawing the most comment.
The DeWalt DCN930B 20V MAX XR is a cordless, brushless framing nailer that uses 30 degree paper collated nails. It needs no compressor or hose. It is made for wall framing, subfloor installation and general structural fastening.
An active flywheel stays spinning for 6 seconds after the trigger is released, which reduces lag between shots in repetitive work. The nose is redesigned for toe-nailing. The magazine is magnesium, and the springs and driver blade are field-serviceable. It drives nails up to 3-1/2 inches and is rated for up to 72% more sub-flush driving than the previous generation.
With a 5.0Ah battery, it is rated for up to 530 square feet of subflooring or up to 100 feet of wall framing per charge. It is sold as a bare tool, so the battery and charger are not included. It runs on DeWalt 20V MAX batteries, works with the optional DZN920 extended magazine, and is Chip-Ready for the TOOL CONNECT system.
