This DeWalt 18V cordless kit has two nailers: the DCN930 framing nailer and the DCN660 16-gauge finish nailer. Both have brushless motors and a fully mechanical drive with no gas. They work at low and high temperatures with minimal service needs, and they run with low noise, no sparks and no gas cartridge waste. The kit comes with two 5.0 Ah batteries, a charger and a bag.
The DCN930 has a switchable firing mode: bumpfire or single shot. Its angled contact tip improves contact with the wood and adds stability. A metal rafter hook lets you hang the tool on rafters and purlins, and the belt hook can be mounted on either side. The compact housing fits between studs spaced only 400 mm apart, and the magazine is magnesium. The 30-34 degree magazine takes D-head nails and round nails with an offset head. The tool drives 90 mm ringed nails in softwood and up to 63 mm in hardwood. A dial at the front sets the drive depth. The tool stops automatically when 6 nails are left in the magazine, which prevents dry firing. A tool-free release frees the drive pin.
The DCN660 is compact and lightweight. It fires nail by nail in controlled mode or in rapid-fire mode, at up to 4 nails per second. Drive depth is easy to fine-tune. The nose opens without tools to clear a jammed nail. Both the trigger and the nose piece must be pressed to fire, which prevents accidental firing.
- Brand
- DeWalt
- Model
- DCK246P2-QW (DCN930 and DCN660 nailers)
- Voltage
- 18 V
- Motor
- Brushless (both nailers)
- DCN930 firing modes
- Bumpfire and single shot
- DCN930 magazine angle
- 30-34°
- DCN930 nail diameter
- 2.8-3.3 mm
- DCN930 nail length
- 50-90 mm
- DCN930 capacity
- 55 nails
- DCN930 hooks
- Rafter hook and belt hook
- DCN930 weight
- 3.9 kg without battery
- DCN660 firing modes
- Single nail and rapid fire (up to 4 nails per second)
- DCN660 magazine angle
- 20°
- DCN660 nail gauge
- 16 Ga, 1.6 mm diameter
- DCN660 nail length
- 32-63 mm
- DCN660 capacity
- 110 nails
- DCN660 hooks
- Belt hook
- DCN660 weight
- 2.7 kg without battery
- Operating temperature
- -20° to 50°
- In the box
- 1 x DCN930 framing nailer, 1 x DCN660 finish nailer, 2 x 18 V 5.0 Ah batteries, 1 x charger, 1 x bag