

eSUN PLA+ is a 1 kg spool of 1.75 mm filament made from a toughened PLA blend. It prints like standard PLA but with better impact resistance and layer strength, which makes it a common pick for functional parts, jigs and prototypes rather than display models alone. Diameter tolerance is held to +/- 0.03 mm and the spool is wound to avoid tangles and nozzle clogs. It runs on any 1.75 mm FDM printer, including Bambu Lab, Prusa and Creality machines. Against plain PLA it trades a little stiffness for toughness; against PETG it is easier to print but less heat resistant. Owners rate it highly for consistency and surface finish.
In stockShips from Singapore · priced in SGD (SGD 21.50) · duties may applyReturn policy
Owners rate it 4.9 out of 5 across 831 ratings, praising consistent diameter, clean winding and strong, smooth prints. Most complaints center on brittleness and the occasional tangled or poorly wound spool.
eSUN PLA+ is a 3D printer filament supplied on a 1 kg spool. The filament diameter is 1.75 mm, and it is made for FDM 3D printers that use 1.75 mm filament. It is PLA+ material and comes vacuum sealed with a desiccant bag.
The recommended print temperature is 215 °C, within a range of 210–230 °C, and the bed temperature range is 45–60 °C. The filament has a dimensional tolerance of ±0.03 mm and a total length of 340–350 m. The reel is wound to avoid overlaps and tangles, and the filament feeds smoothly without clogging the nozzle or extruder.
PLA+ is stronger than standard PLA and has a balance of strength, rigidity and toughness, with impact resistance for functional parts. It can be used for conceptual models and rapid prototyping. The material is biodegradable, non-toxic and low odor.
It checks today's price at every store, compares the alternatives and answers in about a minute.