

The Evolution S185CCSL is a 7-1/4 in. circular saw built to cut mild steel with a 15 amp motor and a 40-tooth carbide blade. It cuts cold, so edges come out workable with little heat, burr or sparks, unlike an abrasive chop saw. The base plate bevels to 45° and, with the rear paddle lever raised, cuts up to 2-1/2 in. deep. At 11.4 lb it is light enough to carry around a fabrication bench. Owners rate it highly for clean, fast steel cuts; it is a one-material tool, so wood and general carpentry are better served by a standard circular saw.
In stockReturn policy
Owners rate it 4.8 out of 5 and praise how cleanly and quickly it cuts steel with little heat or sparks. Most say it replaces slower abrasive cutting for fabrication work.
The Evolution S185CCSL is a metal-cutting circular saw with a 7-1/4 in. blade and a 15 A motor. Its no-load speed is 3,700 rpm, and it weighs 11.4 lb. It cuts mild steel, stainless steel, aluminum, and wood with optional blades.
Paddle levers adjust the base plate for bevel cuts up to 45°, and the rear paddle lever raises the base plate for a cutting capacity up to 2-1/2 in. A clear glass window shows where the blade meets the material. Channeled airflow directs air to the cutting line to clear debris. The base is pressed steel.
At 0°, maximum depth of cut is 2-1/2 in.; at 45°, it is 1-3/8 in. Maximum mild steel plate thickness is 5/16 in., and maximum mild steel square tube wall thickness is 1/8 in. The saw comes with a 7-1/4 in. 40-tooth mild steel TCT blade, a hex key, and a parallel edge guide.
It checks today's price at every store, compares the alternatives and answers in about a minute.












