The Festool TS 75 EQ is a plunge cut track saw that cuts material up to 2-3/4" thick. It leaves a burn-free, splinter-free edge that is clean enough to glue without further prep. It can be used for cutting solid doors, truing rough lumber, cutting out window frames, and cutting stacked sheet goods in one pass.
Used with Festool guide rails, it makes straight, splinter-free cuts. A replaceable splinterguard supports a splinter-free cut on both sides of the blade. The cut is made right on the edge of the scribe line, even on bevel cuts. The plunge action lets you place a cut anywhere along the cut line, and depth adjustment exposes only the part of the blade needed.
A spring-loaded riving knife keeps the kerf open so the material does not pinch the blade, and it retracts into the housing during plunge cuts. A slip clutch reduces the risk of kickback and wear on the blade, gear case, and motor. MMC electronics provide variable speed and hold a consistent speed under load, protecting the motor from thermal and current overload. The FastFix system locks the power switch and arbor together for easier, safer blade changes.
- Blade diameter
- 8-1/4" (210 mm)
- Arbor size
- 1.101" (30 mm)
- Blade speed
- 1,350-3,550 rpm
- Power
- 1600 watts, 13 amps, 120 V AC
- Cut depth on rail
- 2-3/4" (70 mm) straight down; 2-1/8" (55 mm) at 45 degrees
- Cut depth, no rail
- 2-15/16" (75 mm) straight down
- Bevel range
- 0 to 45 degrees
- Weight
- 13.6 lbs
- In the box
- 36-tooth carbide blade, 1 splinterguard, limit stop, Plug-it power cord, SysGen3 M437 Systainer