The High Flow ObXiDian 500 is a complete, assembled hotend for select Bambu Lab printers. It is made by E3D in an official collaboration with Bambu Lab and uses E3D's ObXiDian 500 nozzle coating. The coating is at least 5 times more wear resistant than E3D's earlier ObXiDian range. It is meant for printing abrasive filaments, including UV-reactive and glow-in-the-dark types.
Inside the nozzle, a 4-channel modification improves heat transfer through the filament. This raises the volumetric flow rate by over 60%. It allows more consistent extrusion at the same speeds, or a higher volumetric flow limit in the slicer. Interlayer adhesion is maintained at higher speeds. The coating has low surface energy, which limits filament build-up and makes the nozzle easier to clean between prints.
The nozzle will still wear over time, but much more slowly than a hardened steel nozzle. Some filaments with aggressive fillers, such as Polymaker's Fiberon range, can wear it significantly. Filled materials with particles close to the nozzle diameter raise the risk of jams, so check the filament maker's recommended minimum nozzle diameter. The hotend also works with standard filaments such as PLA. Printing temperature is limited by the printer: 350°C on the H2D, H2S and H2C, and 300°C on the P2S.
- Compatibility
- Bambu Lab H2D, H2S, H2C, P2S, X2D, A2L
- H2C note
- Not compatible with the induction hot-swappable hotend
- Nozzle sizes
- 0.40 mm or 0.60 mm
- Coating
- ObXiDian 500, low surface energy
- Nozzle design
- 4-channel internal modification
- Flow rate
- Over 60% higher volumetric flow
- Max printer temperature
- 350°C (H2D, H2S, H2C); 300°C (P2S)
- Manufacturer
- E3D, in collaboration with Bambu Lab
- In the box
- 1 x assembled High Flow ObXiDian 500 HotEnd