It checks today's price at every store, compares the alternatives and answers in about a minute.
This is a 2.8-inch 240x320 color TFT module built on the ILI9341 controller, with an XPT2046 resistive touch panel and a microSD slot on the back. It talks over 4-wire SPI, so it needs only a handful of GPIO pins, and an onboard level shifter lets it run from 3.3-5 V logic and supply, which means it plugs straight into a 5 V Arduino as well as ESP32, ESP8266, STM32 and Pico boards. Library support is the main draw: Adafruit_ILI9341, TFT_eSPI and LVGL all have ready configurations. Against parallel-interface TFTs it is slower to refresh but far easier to wire, and against OLED rivals it gives you full color and touch at a larger size, though the resistive panel needs a stylus or firm press and the backlight draws roughly 30-100 mA.
In stockReturn policy
Makers widely use this module as a first color touch display because the ILI9341 is one of the best-documented TFT controllers and TFT_eSPI configs are easy to find. Owners like the simple SPI wiring and 5 V tolerance; complaints center on resistive touch feel and modest refresh speed.
This is a 2.8-inch TFT LCD touch screen module with a 240 × 320 pixel display and 65K colors. The display is driven by the ILI9341 controller over 4-wire SPI. On the back of the board are an XPT2046 resistive touch panel and a microSD slot.
The logic runs at 3.3 V, and an onboard level shifter lets the module take a 3.3–5 V supply, so it wires directly to 5 V Arduinos as well as ESP32, ESP8266, STM32 and Pico boards. The touch controller and the SD card each have their own SPI chip-select.
The white LED backlight draws about 30–100 mA. The module measures about 50 × 86 mm, with a 43 × 57 mm active area. Configurations are available for Adafruit_ILI9341, TFT_eSPI and LVGL. It is used for control panels, dashboards, thermostats, game consoles and other projects that need a full-color touch UI without using parallel GPIO.