
3.5" IPS DPI Capacitive Touchscreen Display For Raspberry Pi
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
It checks today's price at every store, compares the alternatives and answers in about a minute.
This is a 3.5-inch IPS touchscreen built to plug straight onto a Raspberry Pi 4, 3B+, 3, 3A+ or Zero through the GPIO header. Its 640x480 resolution is high for the size, and IPS gives 170-degree viewing angles with a DPI interface that drives 262K colors at up to 60Hz. The capacitive panel supports 5-point touch over I2C and sits under toughened glass rated to 6H. It suits compact dashboards, handheld consoles and status displays where a crisp, wide-view screen matters more than size. Against cheaper SPI screens it wins on sharpness and color; the trade-off is that it occupies every GPIO pin and needs a driver setup from the wiki.
In stockShips from the UK · priced in GBP (£24.83) · duties may applyReturn policy
This is a 3.5-inch IPS touchscreen display designed for the Raspberry Pi. It has a 640x480 hardware resolution and uses a DPI666 interface that shows 262K colours at a refresh rate up to 60 Hz. The IPS panel gives 170° viewing angles.
Touch input is capacitive with 5-point touch, driven through an I2C interface and dependent on the operating system. The panel is toughened glass with a hardness of up to 6H.
The display and the touch both run through the 40-pin GPIO header socket, so no cables are needed. A female header accepts the Raspberry Pi 4, 3B+, 3, 3A+ and Zero (W/WH), and standoffs are included to mount the Pi to the display. The display uses all GPIO pins via the female header. Setup follows the Wiki instructions. The Raspberry Pi itself is not included.