This is a solar charge controller with a rectangular housing, an LCD display, three round buttons and two USB-A ports. Six screw terminals run along the bottom edge, and the housing has mounting holes at its corners.
It manages a 12V or 24V system and is rated for 30A or 60A. Charging uses 4-stage PWM management, and the controller works with open, AGM and GEL batteries. The LCD shows system parameters, and the buttons switch displays and adjust settings.
The battery, solar panel and load connect to the screw terminals. The load output is set by light control, with 24-hour, 1–23-hour and dusk-to-dawn modes. The controller is only for regulating solar modules; do not connect another charging source.
- Type
- MPPT/PWM solar charge controller
- Display
- LCD
- System voltage
- 12V / 24V
- Rated current
- 30A, 60A
- Max solar voltage
- 36V (24V battery), 18V (12V battery)
- Max input power
- 390W (12V system), 780W (24V system)
- Battery types
- Open, AGM, GEL
- Charge management
- 4-stage PWM
- Equalization
- 12.6V (sealed), 14.2V (Gel), 14.6V (flood)
- Float charge
- 13.7V default, adjustable 12.0–15.0V
- Discharge stop
- 10.7V default, adjustable 9.0–11.5V
- Discharge reconnect
- 12.5V default, adjustable 11.0–13.0V
- Self-consumption
- <10mA
- Load mode
- Light control
- Load timing
- 24H, 1–23H after sunset, 0H dusk to dawn
- Protections
- Short-circuit, open-circuit, reverse, over-load, reverse current (dual MOSFET)
- Ports
- 2 x USB-A
- Terminals
- 6 screw terminals
- Mounting
- Corner mounting holes
- Buttons
- 3