- Which Delta saws does the DL-1U fit?
- It fits Delta table saws whose throat plate opening measures 13-3/8 by 3-3/4 inches and takes a 1/2-inch-thick insert. Measure your saw's opening before ordering, since Delta used several plate sizes over the years.
- How is a zero clearance insert different from the stock plate?
- The stock plate has a wide slot that lets chips and thin offcuts fall through. This insert has no slot until you raise the blade through it, so the opening matches your blade exactly and supports the wood at the cut.
- Do I need a separate insert for each blade?
- Yes. The slot is cut by the first blade you raise through it, so a different kerf width needs its own insert. Many owners keep one for a thin-kerf blade and one for a full-kerf blade.
- How do I cut the blade slot?
- Install the insert, set the blade to its lowest height, then raise it slowly through the plate with the saw running. Feed slowly and let the blade cut its own slot.
- Is it worth it over a shop-made wooden insert?
- The phenolic plate is flatter and more stable than most shop-made wood inserts and does not swell with humidity. If you cut plywood or veneered stock often, it is a reasonable upgrade.
- Does it work with a dado stack?
- No. A zero clearance insert is cut for a single blade kerf, so a dado stack needs a dedicated dado insert.
- Where is the Leecraft DL-1U Zero Clearance Table Saw Insert for Delta cheapest?
- At Amazon, for $36.95, as of our latest check.
- Where can I buy the Leecraft DL-1U Zero Clearance Table Saw Insert for Delta?
- 2 stores we checked sell it, including Amazon, JB Tools.