- What else do I need to make this strip work?
- A 24V DC power supply rated for the strip's full wattage, plus a CCT controller or dimmer with a 3-pin output. The strip alone will not light without both.
- Can I cut it to length?
- Yes, COB strips are cut at marked points, but on a 5mm board the pads are small and you need a sharp blade and a steady hand. Plan cuts at the marked intervals only.
- Will it fit my existing aluminum channel?
- Only if the channel takes a 5mm-wide, 3-pin strip. Most channels are sized for 8mm or 10mm strips, so measure the inner width before ordering.
- How do I switch between 2700K and 6500K?
- Through a CCT controller that mixes the warm and cool channels. Without one, the strip runs at a fixed color depending on how the pins are wired.
- How much power supply do I need for 5 meters?
- Size the driver to the strip's rated watts per meter times 5, plus about 20 percent headroom. Check the listing's wattage figure, since it is not stated here.
- Is it safe for a bathroom or outdoors?
- No IP rating is given, so treat it as dry-location only. For damp rooms, put it in a sealed channel or choose a strip with a stated IP rating.