Prices are checked against each store and labelled with when.
This is a 1 kg spool of black PETG filament in 1.75 mm diameter, held to a ±0.02 mm tolerance. PETG sits between PLA and ABS: tougher and more heat-resistant than PLA, easier to print and nearly odorless compared with ABS, with low shrinkage and good layer adhesion. It suits brackets, gears, frames and other functional parts for indoor and light outdoor use. It needs no enclosure, but it is mildly hygroscopic and strings more than PLA, so drying and retraction tuning matter.
In stockSold by erafasaReturns: Sold by a Walmart Marketplace seller; returns go to the seller under the seller's returns policy.
This is a 1 kg (2.2 lb) spool of black PETG printer filament with a diameter of 1.75 mm ±0.02 mm. PETG sits between PLA and ABS: it is tougher and more heat-resistant than PLA, and easier to print and nearly odorless compared with ABS. It resists 75–85 °C and suits brackets, gears, and frames for indoor and light outdoor use.
It prints with a nozzle at 245–255 °C and a bed at 75–85 °C, and needs no enclosure. Run the first layers at around 40–80 mm/s, then up to 120–150 mm/s. Low shrinkage and good layer adhesion give clean first layers with minimal warping. A clean PEI or spring-steel sheet at 75–85 °C helps the first layer stick; lower part cooling for the first 2–3 layers, and a squished first layer or a brim stops corner lift. On smooth PEI, use glue as a release layer.
Stringing is normal with PETG. Optimize retraction to about 1–2 mm more than PLA on a Bowden setup, or 0.5–1 mm on direct drive, print cooler, and enable wipe or coasting. PETG is mildly hygroscopic, so spools ship vacuum-sealed and unopened ones print straight from the box. After opening, store the spool in a sealed bag or dry box; if it gets damp, dry it at 60–65 °C for 4–6 hours.
It checks today's price at every store, compares the alternatives and answers in about a minute.







