Prices are checked against each store and labelled with when.
It checks today's price at every store, compares the alternatives and answers in about a minute.
A two-part epoxy kit from Pro Marine Supplies, sold here as the epoxy leveling kit for the Langmuir MR-1 CNC mill base. It includes half a gallon of Part A, half a gallon of Part B and a dark gray pigment powder. Mixed and poured over cured concrete, it self-levels to fill low spots, seal the surface from water and flood coolant, and leave a smooth, nonporous finish that is easy to wipe down. It suits MR-1 owners who run flood coolant and want a flat, sealed base, and anyone coating a small concrete surface. Curing takes about 12 hours to full hardness, and the concrete must cure for 5 days first.
In stock
Lowest price we've seen: $99.95 on Nov 9 at Langmuir Systems. Tracked across 1 store since Nov 9.
This two-part epoxy kit puts a protective, self-leveling finish on the concrete base of the MR-1 CNC Gantry Mill. It is not required on the MR-1, but it fills low spots in the concrete and levels out to a near-perfectly flat surface. It also creates a smooth surface leading to the corner drains when running flood coolant.
The epoxy seals the concrete from water and coolant. The smooth, nonporous surface is easy to clean between projects.
To apply it, mix Part A, Part B and the pigment powder. Pour the mix evenly over the entire surface of the cured concrete until it is fully encapsulated. The epoxy levels itself and takes approximately 12 hours to reach full hardness. The concrete must cure for 5 days before the epoxy is applied.
