The tape is a self-adhesive, PTFE-coated fabric strip used to replace worn, burnt or peeling seal bar tape on vacuum sealers and impulse sealers. The smooth non-stick surface helps bags release cleanly after sealing, and the reinforced fabric resists abrasion from repeated use.
To fit it, unplug the machine and let the seal bar cool completely. Remove the old tape without lifting or damaging the heating wire, then clean and dry the surface. Cut the new tape to length, peel off the paper liner and press it down smoothly over the heating wire without wrinkles or gaps. Match the tape's width and thickness to your machine before ordering.
Make a test seal with a compatible bag and check that the seal is even from end to end. If a gap appears in the same spot on two test seals, inspect the tape and seal bar for damage.
- Material
- PTFE-coated fabric with self-adhesive backing
- Liner
- Peel-off paper
- Heat resistance
- Fabric rated for continuous exposure up to 260°C
- Surface
- Smooth, non-stick
- Compatibility
- Domestic and commercial vacuum sealers, including external bag and chamber models, and impulse sealers that use self-adhesive seal bar tape
- Application
- Cut to length, peel off the liner and press onto the seal bar
- Fit
- Covers the heating wire without wrinkles or gaps