
Spoon Curved Gouge sweep 8 STRYI Profi for Wood Relief Carving
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
The STRYI Profi #8 is a long-bent gouge with a deep sweep, built for hollowing bowls, cups and kuksas. The curved shank lifts your hands above the rim so the edge reaches the floor of a deep cavity at a workable angle. It arrives factory-honed and stropped, so it cuts without a long sharpening session first. Compared with straight gouges it trades flat-work reach for access to concave forms; carvers who hollow a lot of green wood get the most from it.
In stockShips from Ukraine · duties may applyReturn policy
This is a #8 sweep bent gouge for hollowing bowls, cups and kuksas. The curved shank keeps your hands above the rim while the cutting edge works low and parallel to the floor of the cavity. It takes a surface from post-adze roughing through to a clean, finish-ready cut.
The blade is forged from W1-7 high-carbon tool steel and tempered to 58–60 HRC, with a 2 mm thick spine. Each tool is hand-honed and leather-stropped at the factory, and the bevel symmetry and edge are checked before it ships. It arrives ready to cut.
The handle is oak finished with natural linseed oil, shaped for a textured, non-slip grip with the mass set behind the bend for knuckle clearance. The #8 profile is deeper than a #7 and flatter than a full #9 semicircle, so it lifts volume out of a cavity while fairing its own tool marks as the depth is reduced.
It checks today's price at every store, compares the alternatives and answers in about a minute.







