The Bostitch F28WW is a pneumatic framing nailer for structural wood fastening. It drives 28 degree wire weld strip nails from 2 inches to 3-1/2 inches, so it can be used on studs, plates, headers, trusses and engineered lumber.
The magazine holds 100 nails and is angled at 28 degrees. A built-in 16-inch layout indicator helps with stud spacing. A push-button depth guide adjusts drive depth when the material changes. The magnesium design is lightweight, and an over-rafter hook gives the tool a place to rest when both hands are needed.
The nailer comes with a factory-installed sequential trigger and has Bostitch Smart Trigger capability for sequential and contact firing. It runs on compressed air through a 1/4 inch air inlet at 70 to 120 PSI.
- Model
- F28WW
- Type
- Pneumatic framing nailer
- Nail angle
- 28 degree
- Nail type
- Wire weld strip, clip head
- Nail length
- 2 in to 3-1/2 in
- Magazine capacity
- 100 nails
- Firing modes
- Sequential and contact (Bostitch Smart Trigger capability); factory-installed sequential trigger
- Depth adjustment
- Push-button depth guide
- Layout indicator
- 16 in
- Air inlet
- 1/4 in
- Operating pressure
- 70 to 120 PSI
- Construction
- Lightweight magnesium design
- Extras
- Over-rafter hook