

Prices are checked against each store and labelled with when.
A single-channel relay board with high- and low-level trigger inputs and double optocoupler isolation between the control side and the relay. It switches loads up to 10A and runs on either 5V or 12V logic, so it fits Arduino, ESP32 and Raspberry Pi projects as well as small industrial panels. The screw terminals and onboard isolation make it easier to wire than bare relay coils, though it is a basic board with no display or smart features. Buyers comparing it to common blue single-channel modules get optocoupler isolation and dual trigger modes at the same class of board.
In stockSold by YIGOU GLOBALReturns: Sold by a Walmart Marketplace seller; returns go to the seller under the seller's returns policy.
This single-channel relay module board is built for switching signals in home automation, industrial and electronics projects. It uses double optocoupler isolation and can be triggered by either a high-level or a low-level signal. The board carries a 10A capacity.
The module is made of ABS plastic, which resists wear and impact. Built-in overload protection guards connected equipment against damage from excessive current. The connections are designed for setup without special tools, so the board can be wired and tested by professionals and hobbyists alike.
The board measures approximately 40 mm by 16 mm by 19 mm (1.57 in by 0.63 in by 0.75 in). Each package contains one single-channel relay module.
It checks today's price at every store, compares the alternatives and answers in about a minute.











