It checks today's price at every store, compares the alternatives and answers in about a minute.
A drop-in throat plate that closes the gap around the blade on DeWALT contractor saws, so thin strips and veneered stock cut without tear-out. It is a phenolic laminate plate with a bonded melamine surface, 1/2 inch thick and about 13-5/8 by 3-3/4 inches, with off-set leveling screws to set it flush. The blade cuts its own slot on first use, which is what gives the clean edge. It suits owners of DW744, DW745, DW746, DWE745, DWE7480, DWE7490 and DWE7490X saws who want cleaner cuts than the stock insert allows.
In stock
In stockReturn policy
Lowest price we've seen: $24.95 on Nov 17 at ToolCurve. Tracked across 1 store since Nov 17.
Rated 4.9 out of 5 from 51 ratings. Buyers report clean cuts with little tear-out and a good fit on their DeWALT saws.
This is a zero clearance insert for DeWALT table saws. It closes the gap between the table and the saw blade so cuts come out clean, even on very thin strips of wood. It acts as a built-in splinter guard, reducing tear-out along the cut edge.
The insert is 3D-printed from ABS plastic that resists vibration and wear. Its melting point is over 212°F (100°C), which matters because the blade and the insert heat up during heavy use. A spring-loaded ball latch holds the plate in place for tool-free installation and removal, with no screwdriver needed, and it stays put when the saw is moved.
Leveling screws let you fine-tune the height and side-to-side fit so the insert sits flush with the table. To set it up, remove the riving knife if one is installed, lower the blade, drop the plate into the table opening, slide the rip fence over the insert, then raise the blade through the plate to the height you need. The included hex key turns the leveling screws.