The Adafruit DRV8833 breakout is a small dual H-bridge board that drives two DC motors in both directions or one bipolar or unipolar stepper. It runs on 2.7–10.8V motor power and handles up to 1.2A per channel, with 2A short peaks. Its edge over the common TB6612 is lower-voltage operation and onboard current limiting, set to 1A per channel by default and adjustable or removable. It suits robotics and small-robot builders working from low-voltage packs who want a compact, solder-ready driver.
In stockShips from the UK · priced in GBP (£4.50) · duties may applyReturn policy
Makers and robotics hobbyists rate the DRV8833 breakout as a reliable, easy-to-wire driver for small DC motors and steppers. They like the low-voltage range and the built-in current limiting, and note the 1.2A ceiling limits it to small motors.
The Adafruit DRV8833 DC/Stepper Motor Driver Breakout is a small board built around the DRV8833 motor driver chip. It drives two DC motors bi-directionally, or one stepper motor, bi-polar or uni-polar. The chip contains two full H-bridges, or four half H-bridges.
Each H-bridge has two digital inputs, one for each half of the bridge, and one of the inputs can be PWM'd to control motor speed. The board runs at 2.7V to 10.8V, and the motor voltage is the same as the logic voltage; logic voltage of 2.7V or more will work, so 3.3V logic can be used while the motors are powered from 9V.
Current limiting is set for 1A, so the chip does not deliver more than 2A, and the limit can be changed or disabled. Built-in kick-back diodes protect the driver from inductive kick, and a polarity protection FET sits on the motor voltage input. The board measures 26mm x 18mm x 3mm and weighs 1.5g. It comes assembled and tested with a small strip of header, which needs light soldering to attach.
It checks today's price at every store, compares the alternatives and answers in about a minute.






