This is a carbon fiber 3D effect plate for Bambu Lab printers in the X1, X2, P1, P2 and A1 series. It has a magnetic base plate coated on both sides and gives prints a carbon fiber texture. The older 256 mm × 256 mm plate is not compatible with the automatic detection function on 2nd-generation machines (P2S and later models).
The 3D effect sheets are not pre-applied to the plate and must be installed by hand before use. A sheet can be applied to either side of the plate. Bambu Lab recommends applying the sheets only to an official Bambu Lab plate. The Engineering Plate, the other side of the Cool Plate or High Temp Plate, can also be used.
To reapply a sheet to an existing plate, remove the previous sheet and clean off all adhesive residue. The surface must be dry and clean. Grease can make the patterns disappear, so avoid touching the surface and clean it with hot water and detergent. The sheets are consumables, and placing prints on different areas of the sheet extends the life of the textures.
- Texture
- Carbon fiber 3D effect
- Base plate
- Magnetic, coated on both sides
- Compatibility
- Bambu Lab X1, X2, P1, P2 and A1 series
- Bed temperature, PLA
- 60 ~ 65 °C
- Bed temperature, TPU
- 35 ~ 45 °C
- Plate type setting
- Smooth PEI Plate / High Temp Plate
- Installation
- Manual; sheets are not pre-applied
- LIDAR calibration
- Does not work as expected with the effect sheets; skip it or calibrate with a regular plate
- Cleaning
- Hot water and detergent
- Cautions
- Do not apply glue to the sheet surface. Use a scraper carefully to avoid damaging the sheet.