The BIGTREETECH TMC5160T/TMC5160T Plus is a stepper motor driver for 3D printers and CNC builds. It uses SPI as its primary interface and also supports STEP/DIR, UART and standalone operation. The TMC5160T Plus version has low RDS(on) power MOSFETs rated as low as 6mΩ and eight high-power 100V/93A MOSFETs.
It supports motor voltages up to 60V and high-voltage setups from 24V to 48V+. Maximum RMS current is 10.6A, with peak current up to 15A. Microstepping goes up to 1/256.
The driver offers StealthChop2 for quiet operation and SpreadCycle mode, and it includes StallGuard, CoolStep, DCStep, SixPoint ramp and resonance damping to prevent lost steps. Configuration and tuning are done over SPI in Marlin or Klipper firmware. An integrated heatsink has fan mounting holes, and an on-board 24V always-on fan interface supports active cooling. A reserved encoder interface and ESD protection on power and logic are included.
- Brand
- BIGTREETECH
- Model
- TMC5160T/TMC5160T Plus
- Use
- 3D printers and CNC
- Motor voltage
- Up to 60V
- High-voltage setups
- 24V–48V+
- Max RMS current
- 10.6A
- Peak current
- Up to 15A
- Microstepping
- Up to 1/256
- Interfaces
- SPI (primary), STEP/DIR, UART, Standalone
- Modes
- StealthChop2, SpreadCycle
- Features
- StallGuard, CoolStep, DCStep, SixPoint ramp
- MOSFETs
- 8 high-power 100V/93A
- RDS(on)
- As low as 6mΩ
- Fan interface
- On-board 24V always-on
- Encoder interface
- Reserved
- ESD protection
- Power and logic
- Heatsink
- Integrated with fan mounting holes
- Motor compatibility
- NEMA 17 to 86
- Configuration
- SPI in Marlin or Klipper firmware
- Resonance damping
- Prevents lost steps