It checks today's price at every store, compares the alternatives and answers in about a minute.
Bond Craftor's deep pour epoxy is a two-part clear resin mixed 2A:1B by volume, built for thick castings up to 2 inches per layer. Its low viscosity lets it self-level, and the slow exothermic reaction keeps heat down and bubbles minimal, with a 60 to 80 minute working time and full cure around 72 hours at 72°F. The cured finish is crystal clear at 83D hardness with UV stabilizers to slow yellowing. It suits river tables, molds and large castings where clarity and low bubble count matter. Against typical deep pour resins it offers a long working time and good clarity, though the 2-inch layer limit is below what some 4-inch deep pour products allow.
In stock
Lowest price we've seen: $229.99 on Nov 3 at Bond Craftor; highest $269.99 on Nov 13. Tracked across 1 store since Nov 3.
Buyers rate it highly and praise consistent curing, good bubble release and clarity. They say it takes dye and mica well and stays very clear when left untinted.
This two-part deep pour epoxy resin kit is made for casting and thick pours. It can be poured up to 2 inches per layer. It has a low viscosity, so it self-levels to a smooth finish.
The resin reacts slowly as it cures, which keeps heat low and produces few bubbles. It cures to a crystal-clear finish at 83D hardness. UV stabilizers in the formula help resist yellowing over time.
Mix Part A and Part B at a ratio of 2A:1B by volume. Measure accurately for the best results. Working time is 60 to 80 minutes at room temperature.
