

Compared across 8 stores. Prices are checked against each store and labelled with when.
The Elegoo Neptune 4 Pro is an open-frame FDM printer with an 8.85 x 8.85 x 10.43 inch build volume, a PEI magnetic build plate and automatic bed leveling. It runs pre-installed Klipper firmware on a 64-bit quad-core board, which Elegoo rates for print speeds up to 500 mm/s, with input shaping and pressure advance to keep fast prints clean. A direct-drive extruder and a 300°C hotend let it handle PLA and other common filaments. It is one of the faster budget bedslingers, so weigh its features against its recent rivals before you buy.
In stockSold by ELEGOO Official StoreReturns: Sold by a Walmart Marketplace seller; returns go to the seller under the seller's returns policy.
In stockSold by ELEGOO Official Store
In stockSold by elegoo_printer
In stockSold by elegoo_printer
In stock
Availability unknown
Availability unknown
Availability unknown
As an Amazon Associate, Deal.ai earns from qualifying purchases.
Out of stock
Availability unknown
Availability unknown
Availability unknown
Store links may earn us a commission.
Lowest price we've seen: $229.00 on Nov 1 at eBay; highest $239.00 on Nov 15. Tracked across 9 stores since Nov 1.
Owners rate the Neptune 4 Pro highly, calling it one of the best value printers at its price. They praise the speed and Klipper features but note fan noise and the tuning that fast printing demands.
The ELEGOO Neptune 4 Pro is a fused deposition modeling (FDM) 3D printer with a maximum build capacity of 8.85 x 8.85 x 10.43 inches. It has a heated PEI magnetic build plate and automatic bed leveling. It uses a direct-drive filament feeder, a 0.4 mm nozzle, and 1.75 mm PLA filament.
The printer prints at up to 500 mm/s.
The nozzle temperature is 300°C, the minimum layer thickness is 0.1 mm, and XYZ positional accuracy is ±0.01 mm.
It checks today's price at every store, compares the alternatives and answers in about a minute.
