
Our take on the Flashforge ASA Filament 1.75mm
Flashforge ASA is a 1.75mm engineering filament that prints like ABS but resists UV and weather far better. Parts hold their color and shape outdoors instead of chalking or crumbling, which makes it the pick for car trim, brackets, enclosures and other sun-exposed parts. It needs an enclosed printer and a hot end that reaches ABS-level temperatures, so it suits hobbyists and small shops already set up for ABS rather than beginners on open-frame machines. Against plain ABS it trades a little more print fuss for real outdoor durability; against PETG it wins on heat and UV resistance but is harder to print.
- UV and weather resistant, unlike plain ABS
- Similar strength and heat resistance to ABS
- Good for end-use outdoor parts, not just prototypes
- Takes sanding, acetone smoothing and painting like ABS
- Iron Gray hides layer lines and dirt well
Flashforge ASA Filament 1.75mm prices at every store
- WalmartNew
Out of stockSold by Flashforge 3D PrinterReturns: Sold by a Walmart Marketplace seller; returns go to the seller under the seller's returns policy.
$25.99Free shippingChecked 1 h ago
What reviewers say
- 4.2 / 532 ratings
Buyers rate it around 4.2 out of 5 and mostly praise the outdoor durability and steady diameter. Complaints center on warping on large flat parts and the fumes an enclosed setup has to handle.
- UV resistancePraisedOwners say outdoor parts keep their color and strength through months of sun exposure.
- WarpingCriticised
Ask our agent about this product
It checks today's price at every store, compares the alternatives and answers in about a minute.
Questions and answers
- Is ASA better than ABS for outdoor parts?
- Yes. ASA resists UV and weather, so parts do not chalk, fade or crumble in sunlight the way ABS does. Strength and heat resistance are close to ABS.
- Can I print it on an open-frame printer?
- It is not recommended. ASA warps badly with drafts and gives off fumes, so an enclosed printer with good ventilation or filtration is the practical setup.
- What nozzle and bed temperatures does it need?
- Treat it like ABS: a hot end in the ABS range and a heated bed well above room temperature, with an enclosure to hold heat. Check your printer's limits before buying.
- Does it need a heated bed?
- Yes. A heated bed is needed to keep the first layers stuck and limit warping, along with an enclosure for larger parts.
- Can I smooth or paint ASA parts?
- Yes. ASA responds to acetone vapor smoothing and takes sanding and paint much like ABS, which helps on visible outdoor parts.
- What is it best used for?
- Automotive trim and brackets, outdoor enclosures, sporting goods and other functional parts that face sun and weather.
- What do buyers say about the Flashforge ASA Filament 1.75mm?












