
BTT TMC2240 Stepper Motor Driver
Best price now
Prices are checked against each store and labelled with when.
Finding cheaper alternatives
Price facts
- Lowest price today: $9.99 at dfh.fm (checked Nov 17, 2026).

Prices are checked against each store and labelled with when.
The BIGTREETECH TMC2240 V1.0 is an SPI stepper driver for 3D printers, built as a step up from the common TMC2209. It runs on 4.5–36V, delivers 2.1A RMS (3A peak), and does up to 1/256 microstepping with MicroPlyer interpolation. It adds StealthChop2 and SpreadCycle modes, StallGuard4 sensorless homing, CoolStep current scaling and temperature reporting over SPI. It suits builders with a 24V or 36V board and a free SPI socket who want quieter, better-diagnosed motion; TMC2209 owners with a UART-only setup will find it more work to wire and configure.
In stockReturn policy
The BIGTREETECH TMC2240 V1.0 is an SPI stepper motor driver for 3D printers. It runs from a 4.5–36V DC motor supply and delivers 2.1A RMS, with up to 3A sine-wave peak. It is a socketed driver module for controller boards with removable stepper driver slots, not an EZ-driver cartridge.
It supports up to 1/256 microstepping with MicroPlyer interpolation for fine motion and reduced vibration. StealthChop2 provides low-noise movement, SpreadCycle is available for high-speed dynamic control, and StallGuard4, CoolStep and temperature monitoring are built in. SPI is the default control interface, and STEP/DIR is also supported.
Setup uses Klipper or Marlin with TMC2240/SPI configuration. Check the board pinout, jumper settings and firmware driver section before powering the machine. UART support requires hardware jumper work and is not the normal use case. Use active cooling when running high current or higher-voltage builds; a heatsink alone is not a substitute for airflow in an enclosed electronics bay.
It checks today's price at every store, compares the alternatives and answers in about a minute.




