This is a rear-wheel conversion kit that turns a 20-inch bicycle into an electric bike. It uses a brushless, gearless hub motor rated at 36V and 750W, with a maximum speed of 28 mph. The tire is not included.
The kit has a Pedal Assist System (PAS) that senses pedal cadence. It also has a thumb throttle and brake levers that cut power to the motor when you brake. The dual-mode controller lets the motor run with or without Hall effect sensing. The wheel has an aluminum frame and supports up to 220 lbs.
A battery, charger and tire are needed and are not included. The wheel is for conventional bicycles only, not for tricycles, tractors or similar vehicles. Installation at a licensed repair shop is recommended. The kit is CE certified.
- Motor type
- Brushless, gearless hub motor
- Power
- 750W
- Voltage
- 36V
- Max speed
- 28 mph
- Torque
- 50 N·m
- Motor speed
- 500 RPM
- Max load
- 220 lbs
- Wheel position
- Rear
- Bike size
- 20-inch bicycle
- Tire size
- 20" x 2 3/8" to 3" (tire not included)
- Dimensions
- 16 9/16" diameter x 8 7/16" wide
- Rim diameter
- 16 9/16"
- Hub length
- 7 7/8"
- Motor diameter
- 7 7/8"
- Dropout spacing
- 5 5/16" (rear)
- Spokes
- 4 7/16" length, 12G screw type
- Controller
- 750W, 36V, dual-mode (Hall and non-Hall)
- Frame
- Aluminum
- Certification
- CE
- In the box
- 1 motor wheel, 1 controller, 2 brakes, 2 handle bars, 1 thumb throttle, 1 PAS sensor, 1 set of flywheel, 1 set of torque arm, 10 wire ties, 1 spoke adjuster, 2 winding pipes
- Not included
- Battery, charger, tire