Prices are checked against each store and labelled with when.
This is a two-spool pack of 1.75mm PETG filament in black, a general-purpose material that sits between PLA and ABS. PETG is tougher and more heat-resistant than PLA while printing far easier and with less odor than ABS, and it needs no enclosure. It suits functional parts like brackets, gears, jigs and frames for indoor and light outdoor use. Compared with PLA it demands a hotter nozzle and bed and more careful retraction tuning, so expect some stringing until you dial in settings.
In stockSold by ChengYiDReturns: Sold by a Walmart Marketplace seller; returns go to the seller under the seller's returns policy.
This is PETG printer filament in a 1.75 mm diameter, supplied as two 1 kg spools. It sits between PLA and ABS: tougher and more heat-resistant than PLA, and easier to print than ABS with almost no odor. Printed parts resist 75–85 °C, which suits brackets, gears and frames for indoor and light outdoor use.
PETG prints without an enclosure. Run the nozzle at 245–255 °C and the bed at 75–85 °C, at around 40–80 mm/s for the first layers and then up to 120–150 mm/s. Low shrinkage and layer adhesion give clean first layers with minimal warping. A clean PEI or spring-steel sheet, less part cooling over the first 2–3 layers, and a squished first layer or a brim keep corners from lifting.
Stringing is normal with PETG: set retraction to about 1–2 mm on a Bowden setup or 0.5–1 mm on direct drive, print cooler, and turn on wipe or coasting. The filament is mildly hygroscopic, so unopened spools print straight from the box; once opened, keep them in a sealed bag or dry box, and dry damp spools at 60–65 °C for 4–6 hours.
It checks today's price at every store, compares the alternatives and answers in about a minute.







