This solar-powered wall light uses a PIR motion sensor. In daylight it switches off to save energy. In darkness it turns on when it detects motion within 3 m, across a 120° sensing angle.
It has 20 LEDs in a rectangular panel, a circular motion sensor, a power button, and a solar panel on the sloped top of the ABS housing. When motion is detected, the light stays bright for 15 seconds. The solar panel charges the built-in 1200mAh battery in about 8 hours. At 50 activations a night, the battery lasts up to 4 days.
The light is rated IP65 for water and heat resistance, so it can be used outdoors on a patio, deck, yard, fence, pathway or driveway. It needs no wires or adapters and mounts with the supplied screws in a spot that gets enough sunshine.
- Type
- Motion sensor solar wall light
- Light source
- 20 LED beads
- Power source
- Solar powered
- Wattage
- 4 W
- Voltage
- 3.7 V
- Battery
- Built-in 1200mAh, fully charged in about 8 hours of sunlight
- Sensing
- PIR motion sensor, 3 m range, 120° angle
- Light duration
- 15 seconds per detection
- Working time
- Up to 4 days at 50 activations per night
- Switch
- ON/OFF button
- Material
- ABS
- Water resistance
- IP65
- Dimensions
- 4.80 x 3.74 x 1.89 in
- Weight
- 0.31 lb
- Installation
- Screw mount, no wiring; screws supplied
- Setup
- Press the ON/OFF button, peel off the protective film, and charge in direct sunlight for 1-2 days before installing. To test, cover the solar panel; if the light comes on, install it.
