This is a complete rear hub conversion kit built around a 48V 1000W gearless rear hub motor. The motor delivers a maximum torque of 66 N.m and a top speed of 55 km/h. The controller is external, unlike on mid-drive motors. It is typically mounted on the seat tube, usually above a downtube battery.
The motor's O.L.D (Over-Locknut Dimension) is measured without the torque washer, so installation needs an additional 5 mm or more of spacing. The torque washer can be installed on either the inside or the outside of the fork. Check the O.L.D spacing of your frame or fork before choosing a kit. A wiring diagram is provided for the conversion kit.
The wheel is supplied without a tire, so you can keep your original bicycle tire or buy a new one. The brake options are power-cutoff mechanical brake levers or sensors, which automatically stop the motor when you brake. Every kit includes a left-side small-hole PAS sensor, and a right-side large-hole PAS sensor is available as an option.
- Voltage
- 48V
- Power
- 1000W
- Motor type
- Gearless rear hub motor
- Max torque
- 66 N.m
- Top speed
- 55 km/h
- Wheel sizes
- 26 in, 27.5 in, 700C (also supports 28 in and 29 in wheel diameters)
- Tires
- Not included
- Spacing
- O.L.D measured without the torque washer; allow an additional 5 mm or more
- Brakes
- Power-cutoff mechanical brake levers or brake sensors
- PAS sensor
- Left-side small-hole sensor included; right-side large-hole sensor optional
- Display
- UART displays for BAFANG/VARSTROM are compatible; selected in the product options
- Controller
- External, typically mounted on the seat tube
- In the box
- Hub motor wheel, controller, controller box, brake levers or brake sensors, thumb throttle, left-side PAS sensor (smaller hole), 1T4 cable, installation tools
- Optional add-ons
- Display, battery, headlight, tail light, right-side PAS sensor (larger hole); included only if selected