
Voron 2.4 HIGH-TEMP Motor Kit by OMC / Stepperonline - V2.4
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
This is a seven-motor set for the Voron 2.4 3D printer: six NEMA 17 steppers and one NEMA 14 extruder motor, all rated Class H for 180C. The NEMA 17 units (17HS19-2004S1-H) are 48mm bodies with 2A current, 5.9 kgf·cm holding torque and 24mm shafts; the NEMA 14 (14RE08-1004S-H) is a 21mm body with 1A, 1.0 N·cm and a 6mm shaft. The point is heat tolerance: the motors keep working in a hot enclosed chamber where standard 130C-class motors can lose torque or fail. It suits Voron 2.4 builders running ABS or other high-temperature filaments who want BOM-spec parts in one set.
In stockReturn policy
This is a high-temperature stepper motor kit for the Voron 2.4, made up of one NEMA 14 motor and six NEMA 17 motors. The motors are Class H, rated to 180C, and are built to the printer's BOM spec.
Each motor turns 1.8 degrees per step, or 200 steps per revolution. The NEMA 14 motor has a 21mm body, a 6mm output shaft with a 5mm D flat, a 1A current rating and 1.0Ncm holding torque. The NEMA 17 motors have a 48mm body, a 24mm output shaft with a 5mm D flat, a 2A current rating and 5.9Kgf cm holding torque.
The higher insulation class lets the motors run at higher currents and in higher ambient temperatures than standard motors. Running at or near full amperage above 40C will shorten motor life, so in hotter environments the recommended approach is to lower the amperage to extend it. Each motor's four leads connect as A+ black, A- green, B+ red and B- blue.
It checks today's price at every store, compares the alternatives and answers in about a minute.