Prices are checked against each store and labelled with when.
It checks today's price at every store, compares the alternatives and answers in about a minute.
A complete pre-greased idler hub assembly for 6,000 lb trailer axles with a #42 spindle. It comes with bearings, races, a double-lip seal, both standard and E-Z Lube grease caps, cone wheel nuts and spindle hardware already fitted, so the hub goes on without packing bearings or sourcing loose parts. The 6 on 5-1/2" pattern and 1/2"-20 studs match common 6K trailer wheels. It suits owners replacing a worn or damaged hub on a tandem or utility trailer, and it competes with bare hubs and generic kits on completeness rather than on any single part.
In stockReturn policy
The Dexter K08-213-2G is a pre-greased idler hub kit for replacing or servicing the hub on a 6,000 lb trailer axle. It is made for #42 spindles and has a 6 on 5.5" wheel bolt pattern with six 1/2"-20 wheel studs. The finish is painted.
The bearings and seal come installed and pre-greased with Dexter grease, which cuts preparation time and mess during hub replacement. The hub uses a 25580 inner bearing and a 15123 outer bearing, with a 25520 inner race and a 15245 outer race. The double-lip grease seal measures 2.250" ID x 3.376" OD.
The kit includes both standard and E-Z Lube® grease caps, an E-Z Lube® rubber plug, six 60-degree cone wheel nuts, and spindle retention hardware. The assembly is ready to install on compatible E-Z Lube® or standard grease-lube #42 spindle applications.
