
Flipsky Sensored Outrunner Brushless DC Motor Battle hardened 63100
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
The Flipsky 63100 is a large outrunner brushless motor built for electric skateboards, e-bikes and DIY drives. It pairs a 63mm stator with a 100mm body and puts out up to 5500W and 10Nm of short-burst torque, with Hall sensors for smooth low-speed starts. It runs on 4-14S packs, though Flipsky rates 4-12S as the safe ceiling at 190KV. Against smaller 6374-class motors it offers more torque and heat headroom, but it weighs 1.4kg and needs a stout mount and a VESC-class controller.
In stockShips from China · duties may applyReturn policy
The Flipsky 63100 is a sensored outrunner brushless DC motor with a battle-hardened build. It measures 63 mm in diameter and 100 mm in length, and weighs 1.4 kg.
It runs on 4–14S, with 4–12S safe for 190KV. Maximum power is 5500 W at up to 100 A, and the recommended ESC is VESC6. Maximum torque is 10 Nm for very short bursts of no more than 30 seconds.
The motor comes with an 8 mm round shaft or a 10 mm D shaft. Total length is 130 mm with the round shaft and 125 mm with the D shaft. It has 4 mm bullet connectors and a 6-pin JST-PH hall sensor connector, and it is efficient up to 8000 rpm with a maximum of 10000 rpm.
It checks today's price at every store, compares the alternatives and answers in about a minute.




