
Flipsky FSESC 75350 84V High Current 350A ESC Base On Vesc With Aluminum Case Water Cooling Enclosure
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
The Flipsky FSESC 75350 is a high-current VESC-based motor controller built on the 32F405 Cortex-M4 processor, rated for 14–84V packs (3–20S) with 350A continuous at 50V and 250A at 75V, plus an 800A instantaneous peak. It ships in an aluminum case with a water-cooling enclosure, so it is aimed at builders of high-power e-bikes, e-motorcycles, go-karts and similar DIY drivetrains who need sustained current rather than a sealed plug-and-play unit. Against smaller VESC 6-class controllers it trades compactness and simplicity for far higher current headroom and liquid cooling; the trade-off is that it needs plumbing, external heat management and careful current limiting to survive.
In stockShips from China · duties may applyReturn policy
Owner feedback on this class of Flipsky high-current VESC is limited and mixed: builders value the current headroom and VESC firmware compatibility, but report that the controller runs hot and needs real cooling to hold its ratings.
The Flipsky FSESC 75350 is a VESC-based electronic speed controller for brushless motors, built into an aluminum case with a water cooling enclosure. It runs on 14 to 84V, safe for 3 to 20S, and delivers 350A continuous at 50V or 250A at 75V, with an instantaneous peak of 800A. How long it holds continuous current depends on external heat dissipation.
The CPU is a 32F405 running at 168MHz on the Cortex-M4 architecture with DSP function. Digital VCC and analog VCC come from separate voltage regulators, which makes the system's AD conversion more accurate. Motor and power cables are 8AWG. With the water cooling enclosure the unit is rated IP65, and it measures 200 x 94.6 x 50 mm including the height of the water pipes and electrolytic capacitors. Firmware is 5.02, with upgrades available.
It runs sensored, sensorless or in hybrid mode, with ABI, HALL, AS5047 and AS5048A sensors supported. Input sources are PPM, ADC, NRF, UART and PAS, and communication ports are USB, CAN, UART, SPI and IIC. RPM, current, voltage and power limits are configurable, with throttle curve and ramping for every input source and seamless 4-quadrant operation including regenerative braking. Protection settings are adjustable for low and high input voltage, high motor current, high input current, high regenerative braking current with separate motor and input limits, and high RPM with separate limits for each direction. The controller counts motor revolutions, ampere hours and watt hours, and real-time data can be read through the communication port.
It checks today's price at every store, compares the alternatives and answers in about a minute.






