
Flipsky 75200 Pro 84V High Current With Aluminum PCB Based on VESC For Fighting Robot Surfboard AGV Robot
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
The Flipsky 75200 Pro is a single-motor VESC-compatible speed controller built for high-current builds: fighting robots, surfboards, AGVs and large e-skates. It runs 14-84V (4-20S), handles 200A continuous at 50V and 150A at 75V, and bursts to 300A, with an aluminum PCB for heat spreading. It runs VESC firmware 7.0 and is tuned through VESC Tool over USB, CAN, UART, SPI or IIC, with sensorless and sensored motor support. It suits builders who need one big drive with configurable protection and regenerative braking, not plug-and-play hobbyists.
In stockShips from China · duties may applyReturn policy
Owners of high-power VESC builds treat the 75200 Pro as a capable single drive for robots and surfboards, valuing the current headroom and aluminum PCB. The recurring caution is heat: the current figures hold only with good mounting and airflow.
The Flipsky 75200 Pro is a single drive based on VESC for fighting robots, surfboards and AGV robots. It runs firmware 7.0, which supports firmware upgrades. The input voltage range is 14-84 V, safe for 4-20S.
The drive uses a 32F405 CPU at 168 MHz and an aluminum PCB for heat dissipation. It supports DC, BLDC and FOC (sinusoidal) modes, sensorless operation, regenerative capacity and programming through VESC_TOOL. Continuous current is 200 A at 50 V and 150 A at 75 V; burst current is 300 A. These current values depend on mounting, ambient temperature and air or water circulation around the device.
Communication ports are USB, CAN, UART, SPI and IIC; input sources are PPM, ADC, NRF and UART, and supported sensors are ABI, HALL, AS5047 and AS5048A. A single serial port is provided, and a Bluetooth module is integrated for connecting Bluetooth parameters and reading data in real time. An IMU module can connect through the IIC interface for balancing-car function; supported modules include MPU9250, MPU9150, MPU6050, LSM6DS3 and BMI160. Phase filtering is not available; for firmware 5.3 and above (VESC_TOOL 3.01), turn it off and choose "false" in vesc_tool to avoid ESC damage.
It checks today's price at every store, compares the alternatives and answers in about a minute.












