
Flipsky FSESC 110400 High Voltage 110V High Current 400A Waterproof ESC Base On Vesc With Aluminum Case Water Cooling Enclosure
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
The Flipsky FSESC 110400 is a high-voltage VESC-based motor controller built for large electric builds: 14–110V input (4–26S), 400A continuous and 1000A peak. It runs VESC firmware 6.06 and up, programs through VESC Tool, and supports FOC and BLDC with hall, ABI, AS5047/AS5048A or sensorless setups. Its sealed IP68 aluminum case with water cooling suits e-bike, e-motorcycle and large skate builds where heat and current are the limit. Against smaller VESC controllers it trades compactness and weight for far higher voltage and current headroom.
In stockShips from China · duties may applyReturn policy
The Flipsky FSESC 110400 is a high-voltage electronic speed controller built on the VESC platform. It runs on 14–110V, safe for 4–26S, with 400A continuous current and 1000A peak current. The electronics sit in a fully sealed aluminum enclosure rated IP68.
Inside is an STM32F405 Cortex-M4 CPU with DSP running at 168MHz. The aluminum PCB uses a water-cooled system for heat dissipation. It supports BLDC and FOC (sinusoidal) modes, with ABI, HALL, AS5047 and AS5048A sensors or sensorless operation.
Settings are programmed through VESC_TOOL, with current, duty cycle, speed and PID control modes. Adjustable protection covers low and high voltage, over current, and MOSFET or motor over temperature. Regenerative capability is supported, and the controller communicates over USB, CAN, UART, SPI and IIC; two ports can run at once, such as Bluetooth alongside port control. A 5V @ 3A BEC is built in.
It checks today's price at every store, compares the alternatives and answers in about a minute.










