
Flipsky FSESC 110200 High Voltage 110V 200A With Aluminum PCB Based on VESC For Fighting Robot Surfboard AGV Robot/Electric Scooter
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
The Flipsky FSESC 110200 is a high-voltage motor controller built on the open VESC platform, running firmware 6.05 and up. It handles 14–110V (4–26S), 200A continuous and 400A burst, with an aluminum PCB for heat spreading. It suits builders of fighting robots, surfboards, AGVs and high-power scooters who want VESC Tool tuning, FOC or BLDC modes, and a wide sensor set. Against smaller VESC-based ESCs it trades compactness for far higher voltage and current headroom, so it is a specialist part rather than a plug-and-play unit.
In stockShips from China · duties may applyReturn policy
The Flipsky FSESC 110200 is a high-voltage motor controller built on VESC firmware. It runs from 14–110 V, is safe for 4–26S, and handles 200 A continuous current with a 400 A burst. The continuous rating depends on mounting, ambient temperature, and air or water circulation around the device. It is intended for fighting robots, surfboards, AGV robots, and electric scooters.
The controller uses an aluminum PCB for heat dissipation and has a red on/off power switch. It supports BLDC and FOC (sinusoidal) modes, sensorless operation, and regenerative capacity. It is programmable through VESC_TOOL.
Communication ports include USB, CAN, UART, SPI, and IIC. It accepts PPM, ADC, NRF, and UART inputs and works with ABI, HALL, AS5047, and AS5048A sensors. The CPU is an SMT32F405 running at 168 MHz.
It checks today's price at every store, compares the alternatives and answers in about a minute.
















