
Flipsky mini V6.8 PLUS 60V 150A Base on VESC with Aluminum Case
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
The Flipsky Mini V6.8 Plus is a VESC-based motor controller in a machined aluminum case, rated for 150A continuous and 200A peak at 14–60V (4–13S, safe to 12S). It runs VESC firmware 5.2, is programmable through VESC Tool with live data, and supports BLDC and FOC modes with hall, ABI and AS5047/AS5048 encoders. It suits e-skate, e-bike and small EV builders who want a compact, cased VESC with real current headroom. Against bare VESC 6 boards it trades some openness for a sealed case and 8mm bullet connectors; against Flipsky's own bigger units it gives up thermal mass, so the 150A figure depends on mounting and airflow.
In stockShips from China · duties may applyReturn policy
Owners of Flipsky VESC controllers generally report strong torque and smooth FOC operation once tuned, and praise VESC Tool compatibility. Heat and firmware setup come up often, and some units arrive needing a firmware check or connector changes.
This is a VESC-based motor controller built on the VESC 6 design and housed in an aluminum case. It measures 92.7 x 68 x 31.5 mm including the case. The board runs firmware 5.2 and supports firmware upgrades, with programming through VESC_TOOL and real-time data readout.
The controller uses an STM32F405 CPU on an ARM Cortex-M4 architecture. It handles a continuous current of 150A and an instantaneous current of 200A, with those values depending on the mounting and the ambient temperature around the device. It runs on 14V to 60V and is safe for 4S to 12S packs; voltage spikes may not exceed 60V.
It supports BLDC and FOC (sinusoidal) modes, regenerative braking, and the ABI, HALL, AS5047 and AS5048A sensors. Control interface ports are USB, CAN, UART and IIC, and the input set supports PPM, ADC, NRF and UART. Protection covers low and high voltage, over-current, abnormal temperature and MOSFET over-temperature. A balancing-car function works by connecting an IMU module through the IIC interface, with support for MPU9250, MPU9150, MPU6050, LSM6DS3 and BMI160 modules.
It checks today's price at every store, compares the alternatives and answers in about a minute.












