
Flipsky 75100 Pro V2.0 With Aluminum PCB Based on VESC For Electric Skateboard / Electric Scooter / Ebike Speed Controller
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
The Flipsky 75100 Pro V2.0 is a VESC-based motor controller for electric skateboards, scooters and ebikes. It runs 14–84V (4–20S) packs at 100A continuous with a 150A peak, and its aluminum PCB helps spread heat under sustained load. It supports FOC sine wave and BLDC square wave modes, ABI, HALL and AS5047/AS5048A sensors, and PPM, ADC, NRF or UART input, with USB, CAN and UART ports plus a built-in Bluetooth module. It suits builders who want a compact, programmable VESC-compatible unit with strong current headroom; rivals in this class often trade peak current or Bluetooth for a lower price.
In stockReturn policy
The Flipsky 75100 Pro V2.0 is a speed controller based on VESC for electric skateboards, electric scooters, and ebikes. It uses an aluminum PCB. It supports BLDC square wave mode control and FOC sine wave mode.
The controller runs on 14–84 V (4–20S) and handles 100 A continuous, with a maximum peak current of 150 A. Its BEC supplies 5 V at 1.5 A, and its ERPM is 150,000. Firmware 7.0 is installed, and firmware updates are supported. A red power switch button is included, and a Bluetooth module is integrated.
The control interface ports are USB, CAN, and UART. Inputs support PPM, ADC, NRF, and UART, and the controller supports ABI, HALL, AS5047, and AS5048A sensors. It is programmable, has regenerative capacity and a phase filter, and uses 10 AWG wire.
It checks today's price at every store, compares the alternatives and answers in about a minute.




