
Flipsky FT85BD100A Dual ESC 85V 100A With Aluminum Case NON-VESC For Electric Skateboard / Electric Scooter / Ebike Speed Controller / Electric Motorcycle / Robotics
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
The Flipsky FT85BD100A is a dual-channel motor controller for high-voltage builds: 14-85V input, 100A continuous per side and 250A peak per side, all in an aluminum case about 132 x 81 x 26.5 mm. It runs Flipsky's own firmware, not VESC, and is programmed through the Flipsky ESC Tool over USB. It suits e-skate, e-scooter, e-bike and light EV builders who want one board to drive two motors and accept PPM, ADC, UART, CAN and PAS inputs. Against VESC-based dual controllers it trades the open VESC ecosystem and community tuning for higher voltage headroom and a sealed case; expect to lean on Flipsky's tool and documentation rather than VESC forums.
In stockShips from China · duties may applyReturn policy
Note: USB cable black or white will be shipped randomly.
Specifications :
Firmware: V1.4 or above (firmware update via Flipsky ESC Tool supported)
• Voltage: 14-85V (safe for 4S-20S)
• Continuous Current: 100A / Single; 200A / Dual (values depend on the mounting and ambient temperature around the device!)
• Peak Current: 250A / Single; 500A / Dual
• Communication Ports: USB, CAN, UART, PPM, ADC
Input Signals Support: PPM, ADC, UART (compatible with FLIPSKY remote VX4 and VX3Pro only at present), PAS
• ERPM: 150000
Startup Modes Support: IPDS (sensorless), HFPI (sensorless), HALL (sensored), Encoder (ABI, AS5047 encoder SPI interface)
• Multiple Speed Gear levels: Low, Medium, High, Reverse
• Front Lights, Rear Brake Lights & Horn: Support
• Programmable: Yes
• Regenerative Capacity: Yes
• Slide Poweron & Auto shutdown: Yes
• Self-resetting switch with green LED button Diameter: 16mm
• Power Wire Size: 10AWG; Motor Wire Size: 12 AWG
• Size: L132*W81*H26.5mm(Including Alu. Case)
Features:
• Adopting CPU AT32F403ARCT7 with the structure of ARM Cortex-M4 allows CPU clock speed.
• 240MHz and the max PWM switching frequency 45KHz improves the motor RPM.
• Programmable via Flipsky ESC Tool to be compatible with multi-types of motor, different battery voltages and many control ways.
• Programmable via Flipsky remote controller VX4 (remote firmware version: VX4_V1.2.1 or above).
• Supporting motor FOC with low working noise and smooth starting.
It checks today's price at every store, compares the alternatives and answers in about a minute.
















