

The Flipsky Dual FSESC4.20 Plus is a dual-motor VESC-based speed controller for electric skateboards, built on VESC 4.20 hardware with an anodized aluminum heatsink. Its main upgrade over the earlier Dual FSESC4.20 is an integrated anti-spark switch on the board and a slimmer case, so you skip a separate switch and save deck space. It suits DIY builders running two motors who want VESC Tool tuning and a compact, cooled package. Against pricier VESC 6-based dual units it offers fewer features and lower headroom, and Flipsky's own guidance warns that firmware updates can damage it, so it rewards careful setup.
In stockReturn policy
The Dual FSESC4.20 Plus is a dual electronic speed controller based on VESC, with an anodized aluminum heatsink. It uses V4.20 hardware and firmware version 7.0. An anti-spark switch is integrated into the PCBA.
It is rated at 50 A continuous per single and 100 A continuous dual, with 150 A burst per single and 300 A burst dual. It accepts 8 V to 60 V and is safe for 3–12S LiPo cells; the internal BEC supplies 5 V at 1.5 A. Cutoff voltage is programmable, timing is set through software calibration, and the input is PWM. Reverse and regenerative braking are supported, and there is no programming card.
The unit measures 64 x 84 x 20.5 mm including the heatsink. Its thinner build is made for compact cases. Leave the shrink wrap in place to protect the PCB from impurities and metal that could cause a short circuit or damage.
It checks today's price at every store, compares the alternatives and answers in about a minute.









