
Flipsky 75100 75V 100A Single ESC Based on VESC For Electric Skateboard / Electric Scooter / Ebike Speed Controller
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
The Flipsky 75100 is a single-motor speed controller built on the open VESC platform, rated for 14–84V packs (4–20S) and 100A continuous, 120A peak. It runs DC, BLDC and FOC modes, supports hall, ABI and AS5047/AS5048A encoders, and programs through vesc_tool over USB, CAN or UART. Two COMM ports let you add a Bluetooth module, IMU, display or remote. It suits DIY builders of e-skateboards, scooters and e-bikes who want VESC tuning and telemetry in a compact 85 x 50.7 x 33.8 mm case. Against VESC 6-based controllers it trades some refinement and thermal headroom for higher voltage and current ratings at a lower cost, and owners report it works well when kept within its limits.
In stockReturn policy
Owners of DIY e-skateboards and scooters generally find the 75100 delivers strong power for its size and works reliably when kept on the factory firmware and within current limits. Complaints center on firmware upgrade risk and the tuning effort required.
The Flipsky 75100 is a single speed controller based on VESC for electric skateboards, electric scooters and ebikes. It runs on 14-84 V (4-20S) and handles 100 A continuous current, with a 120 A maximum. It supports DC, BLDC and FOC (sinusoidal) modes.
The controller is programmable through vesc_tool and has overheat and overcurrent protection. It has USB, CAN and UART control interface ports, two COMM ports, a 5 V @ 1 A BEC and 12 AWG wire. It supports ABI, HALL, AS5047 and AS5048A sensors, plus PPM, ADC, NRF and UART inputs. It also supports a UART Bluetooth module, an IMU, a screen display or a remote controller.
Keep the factory firmware 5.2; a firmware upgrade can damage the ESC. Phase filtering is not available. With firmware 5.3 or newer in vesc_tool 3.01, turn the phase filter function off and set it to false; leaving it on can damage the ESC. Do not restore default parameters in the wizard interface, and keep the absolute maximum current below 200 A.
It checks today's price at every store, compares the alternatives and answers in about a minute.











