
Flipsky Mini Dual FSESC4.20 100A (Based on VESC ) with Anodized Aluminum Heatsink
Best price now
Prices are checked against each store and labelled with when.

Prices are checked against each store and labelled with when.
The Flipsky Mini Dual FSESC4.20 is a dual-motor VESC-based speed controller for electric skateboards, built on VESC 4.20 hardware with an anodized aluminum heatsink. It runs two motors from one compact board, delivering 50A continuous per side and 100A combined, with 150A instantaneous per motor. It handles 3S to 13S LiPo packs and supports DC, BLDC and FOC modes with programmable cutoff and reverse. It suits builders who want a small dual VESC setup without paying for a higher-tier controller, though it is a DIY part that expects careful wiring and firmware discipline.
In stockShips from China · duties may applyReturn policy
Warm tips:
It is recommended to keep firmware 5.2 from factory ship, the new firmware upgrade may damage the ESC.
please do not remove the shrink to protect the pcb electronics components from impurites or metals which result in short circuit or esc burnt damage.
Specs
• Hardware:V4.20
• Firmware:Latest Version
• Current:50A continuous/single, 100A continuous/dual , Instantaneous current 150A per single, total 300A for system instantaneous current.
• Voltage: 8V-60V (Cells: 3-13S LiPo,Safe for 3S to 12S LiPo,Voltage spikes may not exceed 60V! )
• ERPM:60000
• BEC: 5V@1.5A
• BEC type: Internal driver support
• Modes: DC, BLDC, FOC (sinusoidal)
• Timing: Software calibration
• Cutoff Voltage: Programmable
• Frequency: PWM input
• Governor: No
• Programming card: No
• Reverse: Yes
• Motor wire: 12AWG
• Power cable: 12AWG
The shipping package contains:
• 1*Dual FSESC4.20 + Heatsink
• 2*VESC Sensor Wires
• 1*Micro USB
It checks today's price at every store, compares the alternatives and answers in about a minute.











